...it. please check and make sure the knobs are not stuck in pull on each of them the oven does not spark it has a glow bar but there are switches behind the knobs that maybe sticking check that ...
Question about Rangemaster Kitchen Ranges
oven with the draw underneath. The gas lights ok with no problem, but it doesn't matter where you turn the control knob to, the flame remains small and the heat doesn't get above a 'keeping warm level
...sticking out the back of the oven. Note: Your temp test method is not accurate enough to calibrate oven exactly. I take average temp after a minimum 3 on / off cycles using a digital calibrating oven ...
Sticking Knob I have a Maytag Performa gas/electric range. Today when I turned the oven on the knob was stiff. It is only getting stiffer as the day goes on and we cook. Any ideas? there is nothing to
Question about Rangemaster Kitchen Ranges
...the oven is the source of the problem, i think that the contact behind the knob of the oven sticks It looks like this one and is behind the facia, between the knob and the valve. I hope this helps, ...
Garland Range I have a Garland Range product and the age is unknown. It has some numbers that I can identify. One of these may be the model number: T8-11J 511-112-401 H284-24G (searching for this on ...
Question about Kitchen Ranges
the oven temperature number decal has worn off the stainless steel fascia that surround the knobs is it poss to buy new stick on replacements Some times these are printed on to the plate by etching ...
oven,i went over,had to change out both ignitors and both burner tubes,the ignitors weren't working correctly and burnt a hole through the tube.so check the ignitors first,if you want to calibrate
...oven, the knob was pushed in and now we don't seem to be able to get it to come out again. It seems well and truly stuck! problem is caused by the sprung mechanism within the control knob sticking ...
...knob to use the oven, the CLEAN light blinks. When this happens, the oven does not ignite to cook at the asked temp, just blinks to clean. The clean cycle still works properly. I have tried to reset ...
129 questions posted
Usually answered in minutes!
24 Questions
13 Questions
2 Questions
2 Questions