2010 Volkswagen Jetta "replacing front control module" Questions

Ad

Question about Volkswagen Jetta

1 Answer

...control unit at front r/h chassis from down or flow fan motor cable it;s conect with control A/C pressure S.W look to two freon hoses gose to body if you folow you find the presure s.w conect with ...

Ad

control the gas door closes, but when I open the doors with the remote the gas door also opens, the car had an accident and was hit on the front on the passegers side, so recently replace the car&

Ad

Question about Volkswagen Jetta

3 Answers

...Front Wiper Motor, Washer Pump S25=25 AMP=Fresh Air Blower, Climatronic, A/C S26=25 AMP=Rear Window Defogger S27=15 AMP=Rear Wiper Motor S28=15 AMP=Fuel Pump, Gas Engine Only S29=15 AMP Gas/10 AMPS ...

...control module, coolant temp sensor, fan switch, 4 terminal connectors. No trouble codes reported in VW electronic diagnostic test. 2 different VW dealers and and my mechanic threw in the towel. Any ...

Question about Volkswagen Jetta

2 Answers

control module may be bad. Its under the lower rad support. .......or try to jump the fans , where the red wires connect are power, where the brown wire would connect is ground. good luck.... Also, if

...Front Control Module and Power Distribution Center, and is located next to the battery on the left inner fenderwell (the Front Control Module is underneath the Power Distribution Center, where you ...

Question about Volkswagen Jetta

2 Answers

...replacing. What is it? If it is either of those or something else entirely please inform me and tell me where i can get a diagram. becuase im not paying anybody anything to fix if i can do it myself. ...

front body control module on a 2004 oldsmobile bravado HELP ANYONE!! body control module - GM Parts Online www.gmpartsonline.net/.../2004/Oldsmobile/Bravada/Base?...CONTROL... Genuine Original ...

...control module (TCCM) is located under the drivers seat carpet. For removal purposes, access the TCCM from underneath the carpet. Remove the drivers bucket seat or split bench seat. Refer to Front ...

...front fender apron. Secure with the retaining bolt and tighten to 35-50 inch lbs. (4-5.6 Nm). Attach the engine control sensor wiring connector to the ignition module. Connect the negative battery ...

Not finding what you are looking for?
2010 Volkswagen Jetta Logo

71 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...