Pioneer SD-533HD5 53" Rear Projection HDTV "stk392 110 fuse" Questions

STK392-110 convergence IC in two places. Is there a better IC replacement, I thought that I had read a clip about replacing it with an STK392-180 in a Panasonic unit. I have gone into the menu to make

...STK392-110 IS THIS THE PROBLEM, I ALSO HAVE A ANOTHER CHASSIS NOT THE SAME, IT HAS 2 STK392- 010 CHIPS ARE THESE INTERCHANGABLE. REGARDS MARK, ALSO IS THERE A PROTECTION RESISTER OR FUSE FOR THOSE ...

...stk392-110? thanks This is like a quiz right?? Let's see ;;;;;;; by convergence resistors I assume you mean the yoke return resistors out in front of the amps. There are 6, in the 2.2ohm 1w range, ...

...stk392-110 and stk392-020 ic. Is this something a total novice should attempt? Thanks Replaced one fuse, and the stk392-020 ic. The stk392-020 was not an original Toshiba part but the alignment is ...

53sdx89ba double vision. colors will not align check ik04,ik05(stk392-110,if bad,replaced with stk392-150).resistors:rk46,rk54-1,5ohm.,rk42,rk50-2,2ohm.,rk58-3,3ohm.,rk62-1,8ohm.also check line fuses.

...Convergence IC's that should have been used are STK392-570's. These are not interchangeable with STK392-110's. I would try the STK392-570's first before doing anything else. I hope this helps, ...

...STK392-110 on convergence board must be replaced. Before replacing the ICs you can test the pico fuses located on convergence boards. Simply read ohms to test if they have continuity. Better also ...

STK392-110 My SD-P50A50-K goes to standby mode right it is turned on. After reading from this site, I decided to replace the two STK392-110 ICs in the convegence board. Now I face troble to disaeembly

...STK392-110,but I replace them with STK392-150.If there are still issues check resisters close to heat sink,also check the pico fuses.This isn't a do it yourself job unless youv'e been around a hot ...

...ICs STK392-110 Pico Fuses Look like resistors ,but they will be Yellow or Green 5amp -7amp fuses. If they are Ok then you need to replace bopth ICs . Mats Electronics has ICs ...