...value the resistors are? Here is my previous post if you would like to see it. http://www.fixya.com/support/t191186-blue_out Power supply LED on 1sec power off and 110voltage dub no picture rainbow ...
...value resistors in the circuit. Replacing with the STK 392-150 will cause overheating of the resistors and a damaged IC. If you are in Calgary, I can help. If not, get someone that has experience ...
...resistors out in front of the amps. There are 6, in the 2.2ohm 1w range, easy enough to find. The value of the convergence amps, that unit uses two stk392-110 Sanyo original Ic's rated at 6amps. You ...
...resistors on the convergence board I noticed that RK50 was discolored. I want to replace this resistor but I do not know what the resistor value is. I looked through the Hitachi service manual (No. ...
...value resistors in the circuit. Replacing with the STK 392-150 will cause overheating of the resistors and a damaged IC. If you are in Calgary, I can help. If not, get someone that has experience ...
...resistors in the circuit as they may be off now pay close attention to the resistors that have a value less than 10 ohms these are critical to the correct alignment if in doubt replace the
...Resistors are burnt to the point that I can't read the value, and I don't have a schematic. The board number is P55A AA41-00601A and the parts location numers are RZ142 and RZ143. If anyone has a ...
...IC's. no help. I'm moving on to the convergence fuses and then resistors. I found this site which gave me the values of each from a kit they sell. Hopethis ...
...value by looking at some of the resistors near the other ic's as they are the same value. The circuits for each IC is some what the same with slight differences.. You will also have to make sure the ...
58 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions