Mitsubishi VS-60611 60" Rear Projection Television "4 ohm" Questions

...4 is listed as an overflow in the convergence section. To fix: 1. Check the placement of the sensor 2. perform an Adjustment check of th H/V size & centering 3. Conv. amp. gain check, check these ...

...ohm 1/4 watt or 1 ohm 1/2 watt or 10 ohm 1/2 , 1/4 watt some times the bigger one like 100 ohms, the bigger than 100 ohm just changing the value and make problem. Please do accept the solution if the ...

...ohm 1 watt resistors. Any other resource you might suggest? They have it, they just list it as a 1-4 watt resistor, just order two of the 1-4 watt resistors and they will send a order confirmation ...

...are 3 ratings for the resistors and there are 4 of each rating for each IC they are 2.2 ohm 1watt 2.2K ohm 1 watt and 3.3K ohm 1 watt. You can get replacements here.

...resistors: 1.5 ohm 1w,,,1.8 ohm 1w,,,2.2 ohm 1w. (watt). I would by 4 each. Your soldering skills will come into play so roll up your sleeves and go to work.....Good luck ! and let me know how you

4.7 ohm 1/2 watt resistors or the 6 pico fuses? I did buy 6pc 4.7 ohm 1/2 watt resisters but I don't know where they are located on the circuit board. Thank you. If you look at the Convergence ICs you

...FOR 34V ON PIN 6 OF IC401. IF LOW OR MISSING, CHECK R510 (.82 OHM 1/4 WATT) OFF PIN 5 OF THE FLYBACK ON THE MAIN PCB. 5. MAY BE INTERMITTENT. CHECK SOLDER CONNECTIONS AT CONNECTOR "DY" ON THE ...

...Ohm resistor (R) between pins 4 and 5 of the IC951. This discharges C960 that may still be charged if the Over Voltage Protect circuit was activated. 3) Remove the 100 Ohm resistor and apply power to ...

4 are the only ones with that type resistor everything else is the baby blue 6.8 ohm you mention .... so do you think someone put something there in its place wrong ? if so should i put back the right

Help with Philips resistors I too have a problem with my Philips 43PP930217 where I am having trouble with the red convergence lining up. I have pulled the board which shows two burnt out resistors. ...