Mitsubishi WD-52525 52" Rear Projection HDTV "lamp not light" Questions

...lamp light on front panel display. I belive there is a "lamp motor" and it was maing an ever increasing humming sound prior to my picture going out. Does the blinking "lamp" light on front display ...

light engine.Cause 5. Lamp enable line at connector J14 pin 6 on the light engine does go to 5 volts at turn on, but does not drop back to 0 volts after 5 seconds, but your 12 and 5 volts supplies are

lamp" light stays on Red "lamp" light stays on and screen will not light up. Red light indicates the lamp has failed to light. You may just need to buy a new lamp. If that does not help then

Lamp Light Red - No Screen Image When we turned on the TV, the lamp light turned on a constant red. The lamp light never even flashed green with a warning. The screen was black and there was no image ...

...LAMP LIGHT!! Just replaced lamp on my Mitsubishi WD-62531 yesterday everything worked fine for about a hr then it just shut down and the red lamp light is on again. Please Help!! Check to make sure ...

...lamp light stays a steady red. I've tested the new lamp and think it is bad, but I would like to know the correct voltage to look for on the lamp connection before I put in another lamp. I'd hate to ...

...lamp light. No picture. Lamp is good. My WD-62525 was working fine. Went to change channels with remote and picture went out, audio stayed on. Lamp light went to continuous amber. Turned set off. ...

...Lamp light is still blinking yellow, the timer light lit up green, but lamp still blinking yellow Are you sure you installed the lamp properly and put the door back so the interlock switch is ...

...light, under lamp blinks Please put back lamp cover, the last plastic grille that were removed to replace lamp in TV. TV sense that lamp cover is not either put back or not fixed properly so it wont ...

...lamp light still blinks replaced new lamp lamp light still blinks Hello, make sure that all the covers are on properly, was the old lamp broken? If it wasn't it may have not been the problem, ...