Mitsubishi WD-62525 62" Rear Projection HDTV "side screen gone dark" Questions

...side of the screen frame. There's 8 -- six down each side and two along the top of the back. 4. CAREFULLY shift screen forward, opening access to the inside enough to reach small inside mirror with a ...

...side of the housing behind the screen held in by a single phillIps head screw. Remove one of them to expose the interior which houses the projection bulb and the mirror. Take a large microfiber cloth ...

...side of screen. Picture can be seen behind the dark streak. Dark streak appears to be getting larger with age. Your TV has a bad light tunnel. This part is inside the light engine. A qualified tech ...

...side of the screen, and consistently gets wider as it moves up the same side of the tv until reaching the top left side of the tv. (The same side the shadow started from) At the top the shadow is ...

...screen immediately ofter the process starts. Any suggestions would be most appreciated. Sounds like your convergence chip has gone bad. Usually costs about $300-$400 to fix. I would call a local TV ...

side of the screen. Noone can tell us how to fix this. Is there an expert who can? Thank you There are four tiny mirrors forming a tube (app 50mmx15mm) next to the color wheel, and they are the reason

screen controls are set to just below the point where their faint lines are visible. When done, replace the panels and your picture will be back to perfect. MikeNJ1964 was exactly right! I have a Sony

...side panel off like previously stated, but you can use just a can of compressed air to clean the little screen on the bottom of the TV. Took 2 mins...screen is clean. Awesome post!!! I had this dark ...

...screen" voltage, which has an effect on the brightness of the picture. Often focus dividers will crack when they fail, so you may be able to spot a problem with this part by visual inspection. Other ...

...screen(usually a plastic part) most of the time it is secured with 3 screws on either side of the set in the back; once you remove the screws the entire piece should pull out(pull from right to ...