Question about Porter Cable Air Tools & Compressors
...COMPRESSOR, THE HOSE SHOULD BE ATTACHED TO THE REGULATOR OR THE REGULATOR STACK, NEVER TO THE COMPRESSOR, AS THE COMPRESSED AIR LOSES MUCH OF ITS HEAT WHILE IN THE RECEIVER. IF THE WHOLE TANK IS ...
Question about Porter Cable Air Tools & Compressors
compressor. I have returned this ubit for a full refund. So to answer your question, "what would cause a rubber hose to get extremely hot" it is normal for all compression tubings and hoses to run hot
Question about Porter Cable Air Tools & Compressors
tank and the hose from the motor to the tank gets extremely hot. Is this normal for the hose to get that hot. The air discharge hose will normally get very hot. When the pressure regulator valve fails
Question about Coleman Air Tools & Compressors
...hose will get to hot to touch in 15-20 minutes of use. The tank itself will get warm. I believe the only place that could generate this heat is the pump piston, part #048-0774. Does anyone believe ...
Question about Porter Cable Air Tools & Compressors
The compressor will not shut off when it reaches top pressure, over 150 psi. The hose from the head to the tank gets too hot to touch. The pressure controller is bad, so change it.
Question about Porter Cable Air Tools & Compressors
...hose from top down to tank gets very, very hot while filling. About 2 years old. Please assist if possible. Thank you Check the bottom of the tank for the air release valve and make sure it is ...
Question about Air Tools & Compressors
...hose). I would love to replace but everything sold these days seems to be tank based, and everyone seems to say you can't use a tank compressor for painting (just spray painting the house or ...
Question about Craftsman Air Tools & Compressors
compressor will only hold 20 lbs and looking for some troubleshooting ideas First check for obvious air leaks: 1. The drain valve on the bottom of the tank. 2. The air hose, both end connectors and ...
...compressor builds pressure real slow now. Rings or Valves? it did get a little warm while sandblasting lately.... Very rare to have problems with rings. Blow-by would produce high pulsating pressure ...
Question about Hitachi Air Tools & Compressors
...hose at check valve spray soapy water. If check valve good, suspect reed valves leaking. If reeds are leaking the compressor will take longer than normal to fill and the discharge tube/air will get ...
226 questions posted
Usually answered in minutes!
29 Questions
25 Questions
27 Questions
32 Questions
16 Questions