Yamaha RX-V1500 Receiver "relay clicks powering" Questions

...On power up the display lights but no sound is produced by the unit. When working normally a click (relay?) is heard about 5secs after power up and normal speaker output then follows. When the unit ...

...I POWERED I HEARD A CLICK BUT EVERYTHING OFF NO LIGHT.I CHECK BOTH FUSES AND ARE OK. There is a relay on the power supply circuit board that might be faulty or has bad solder connections. If this ...

relay clicks sound works for a few minutes then relay clicks again and sound stops. display stays on. Hi there, can anyone help me? i cant seem to get my aiwa-d58 to get out of eco mode. no power, red

clicks the relay on power board non stop relay on powerboard clicks continuously Sounds like your power transformer is bad. You might also check the power board for cracks. This model had a history of

...relay clicks. You should hear the power relay click at power on and 3 to 5 seconds later you should hear the speaker protection relay click if your audio amp section is ok. If you hear both relays ...

relay clicks, fuses BLOW! The unit powers up, relay clicks and the display works and all menus are intact. It's the two 8amp 125v fuses next to the transformer that keep blowing. It just happened last

Amp turns on I think its a relay little black box click have power click of it goes can I jump this out Sx315 and black box has 9vdc on it The click you hear is the relays switching on the power amp ...

...relay clicks. It may need the main power transformer. Primary of the transformer should be almost a short, if it is open-it's bad. If no relay click. It could be main micro, stand by relay or the ...

...clicks) My theory is the power relay has gone bad. ( electrical strike bad storm ) 8amp fuse was changed - never blown from storm. Dont remember the relay ever clicking twice before. Relay marking on ...

...relay clicks, this means that the coil is good but the relay contacts may be dirty (contacts need to be cleaned or the relay replaced). If the relay does not click, then it might be a bad fuse, a bad ...