Pramac 5000 Watt Generator "new runs rough" Questions

...runs rough then dies, several tries and it will run rough and eventually smooth out and run ok, also intermittant loud clicking sound,think its the fuel pump sounds like u need a new fuel pump when u ...

...runs for awhile then the air cleaner cover and carb start filling with gas i took it apart cleaned checked the needle valve and float put in a new fuel pump and the electronic part on the bottom and ...

...new gas. runs ok at half choke but when go full choke it starts backfiring and runs real rough if you are running the engine at full CHOKE, then it is flooding the engine, but if you meant off full ...

...runs rough and never ''settles'' to a smooth rpm like hondas I've seen. I am a very new to generators and this unit was given to me. You probably need to do a tune up. Change the spark plug, oil, air ...

rough, which worsened to bangs & pops from In & Outlet occasionally, and became difficult to start. Suspected water in fuel, so drained & refilled tank, cleaned sediment trap, checked filters, cleaned

...runs really rough won't idle smooth There probably is a pin under the float may be clogged. Take it a part disassemble let it all set in carb cleaner, and then put new gas in it with fuel stabilizer ...

...runs real rough and smokes now??? Does this sound like a fouled plug? Full of Gas and Oil. Air filter is new. If plug is fouled, that would explain running rought and some smoking. But for something ...

runs rough under load check spark plug or plugs then carburator. Like any internal combustion engine... fuel, air, spark, compression, timing. This is a propane/natural gas engine, so we won't have to

...runs fine. I'm not quite sure if your issue may relate to most inverter and auto-load sensing generators or some gas-powered equipment. Most power cutters/grinders such as Stihl or Husqvarna, ...

...runs a little rough and when i plug in an ac power unit (eg. lights), the unit goes on and off and simply won't stay on for any length of time. it started doing that after i replaced piston rings ...