Husky Husqvarna Chain Saw 240E w 16in bar "dies pull trigger" Questions

...pull the trigger it dies it start fine , then i pull the gas switch it dies on me ? Running to lean, replace the fuel filter in the tank, turn the H screw on the carb out 1/4 turn to richen the ...

...pull the trigger. Even though the rpm never get high enough to properly start moving the chain, there is no sign of movement by the chain whatsoever. Then it starts to smoke and run poorly and then ...

Chainsaw will start and idle if choke is pulled out, but when choke is pushed in or trigger is pulled to saw (thus deactivating the choke) the chainsaw dies. Let it warm up first ...

...dies after a few seconds when i pull the trigger If you empty out the tank and fish around in there, you should be able to pull the rubber fuel line with the filter on the end of it out. Pull the ...

chain saw not working right chain saw idles when choke is at half way, dies when the trigger is pulled unless you butterfly it Running too lean, replace the fuel filter in the tank as a start.

runs fine but chain wont turn. clutch spins but when you pull the trigger it tries to die out. the fuel system is clogged,,,,,,,need the carb rebuilt or fuel inlet restriction fixed

My chainsaw starts and idles fine but when I pull trigger to a point that butterfly opens it bogs down and almost dies. Has fresh fuel Fresh air filter?

...pull the trigger to accelerate my saw it loses power and stalls. I have to "pump" the trigger to get it up to speed. Even then it will die out while cutting. Then it is difficult to start.It has been ...

...pull the trigger, the engine quickly loses RPMs and will die if I do not let go of the trigger. Spark plug and fuel screen are both OK. What is causing the accelerator trigger to act like a choke? u ...

...will cut wood with out pulling trigger. Runs is very vast, dies when pull trigger. I would say it has an air leak, through a gasket or crank seal, make sure the carb is tight and sealing