Husky Husqvarna Chain Saw 240E w 16in bar "chainsaws hard restart" Questions

...hard to restart close chock it will restart open chock and it will start and again die after a few minutes. any ideas Try fresh fuel making sure oil and gas mixture is correct. Carb might need ...

...restart. I've done everything but adjust the carburetor. I have the carburetor adjustment tool but don't know how to set the screws properly. make sure you have the right spark plug and gap is right ...

Stihl ms310 chainsaw will only run on choke can anyone advise me on adjusting the high low and air adustment You actually need the adjustment tool,looks lie a small screwdriver with a smal socket at ...

...is hard to restart. Check the fuel filter, air filter and muffler for plugging. Make sure the carburetor fasteners are tight. Does the primer bulb fill with fuel after several pumps? Hope this

...hard to start and when warm will not restart Try putting a spark tester on the plug. Run the saw and when it dies see if you can generate spark by pulling the cord, if not your coil needs to be ...

hard to restart it . rope pull seems tight too. Cylinder gasket opening up or blown rebuid or replace gasket check for severe scorch in cylinder bore only when hot is your clue expansion leak pressure

...hard sawing there is a ping sound and then the engine quits. After letting it set for about 15 mins I am able to restart the saw and begin sawing again. But once again after about 8 mins of sawing ...

...I've heard the magnetos might be the problem but I don't know for sure. I would try richening up the high speed very slightly. If the saw is running a little lean(hot), will make it hard to

...minutes working hard then stops suddenly and will not restart for several hours. No spark when it cuts out. Could also be the condesor that is temperature sensitive and most likely cheeper to ...

...won't start Has always been a hard starter and frequently would quit when hot and not restart. Now will now start at all. HELP Sounds like somethings blocked mate, strip it down and clean it ...