Briggs Stratton IC Horizontal OHV Engine 305cc 1450 Series 145 Gross Torque 1in x 3 2132in Shaft Model 2053320537B1 "1450 305cc problems" Questions

Ad

Question about Briggs Plumbing

1 Answer

Engine stops after a short run There is probably a fuel flow problem. Either a dirty valve in the float bowl or a faulty fuel pump if fitted or dirty fuel filter. If the engine runs after being left a

Ad

I have Poulan tiller with Briggs & Stratton 5.5 hp engine. It runs only on full choke. Doesn't go to higher RPM. What may be the problem? you have a gloged carb try takeing it off and blowing ...

Ad

can get the engine to fire by spraying starting fluid into the air intake but will not continue to run. Fluel is getting to the carburetor. Hi, it sounds like a problem with the fuel not going through

Question about Briggs Plumbing

1 Answer

20 hp intek will only run as long as pour gas in carb, tried 2 other carbs, with same result. Hi there it seems as if you have a blocked fuel delivery line, take a look at the supply by means of ...

Question about Briggs Plumbing

1 Answer

Briggs 3.5hp model 94212 0319E1 0206113A , on a lawn edger..unit unused /stored last nov 'til now..had gas stabilizer in tank..wudnt start..removed/cleaned carb..flywheel had rust on magnets/sanded, ...

Can,t get voltage to spark plug. Checked condensor and points and they are both ok. How do you check the coil ? I,ve tried with a ohm meter but I,m not sure what I should get as far as readings on the

how to adjust over values on 18hp briggs engine It's pretty easy but since this is the pump section not the engine section.....4 to 6 thousandths each valve or 0.1 to 0.15 mmAdjust only if you are

Question about Briggs Plumbing

1 Answer

Got a 10hp generator motor it has spark and replace plug just to be sure pulls fine put gas directly in carb and still doesn't run took plug out and it doesn't seem to be wet do you think it is a ...

Question about Briggs Plumbing

1 Answer

12 hp oil pumping into the carb with the hose on the valve cover hooked sound like you are getting some blow by. check to make sure all filters are clean first. but more then likely it is going to ...

Question about Briggs Plumbing

1 Answer

I have a 3.5 horsepower B&S push lawn mower. It is easy enough to start, but once started it fluctuates. Runs high and then low almost as if it will cut off and then it runs high again. What can I

Not finding what you are looking for?
Briggs Stratton IC Horizontal OHV Engine  305cc 1450 Series 145 Gross Torque 1in x 3 2132in Shaft Model 2053320537B1 Logo

101 questions posted

Ask a Question

Usually answered in minutes!

Top Briggs Plumbing Experts

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

Are you a Briggs Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...