...few seconds and cuts off. prime it and starts but only runs for a few secounds and cuts off again check gas line in gas tank. See if Stone filter broke off of gas line. Very common with this new ...
...few minutes cuts off and is hard starting again won't stay running to cut lawn You may want to check the gas cap to see if it clogged with dirt. If the gas cap is clear, you more than likely have a ...
...cuts off and won't restart Hello; This is likely a carb problem or clogged fuel line or fuel filter if it has one. If it runs for awhile before cutting out, check your gas cap. They all have some ...
...run a few times like that and it will flush the gunk out of the jets, but most of the time you will need to rebuild the carburetor. If the mower is over a couple years old, then I also recommend that ...
Question about Garden
Why is the engine running rough after a few minutes and the spark plug gets carbon on it? The mower starts fine. The spark plug gets carbon on it within a few minutes and it runs rough. Air filter is ...
Question about Craftsman Garden
...run erratically then cut off. There was a slender rod that ran from an actuator on the carb to somewhere on the enginethat when you move it to very particular areas the motor will start but then it ...
...and it will run for a few seconds. sounds like the carburetor needs cleaning OR your gas tank Vent is clogged. Try the easy thing first. loosen the gas cap and see if the mower will keep on
...run but if i shut it off it wont start again until it gets cold what engine do you have and how long has it been doing it for, try a new plug at first. Brian my 1042 just died while cutting have not ...
Question about Mtd Garden
...run well from 30 seconds to a few minutes...but it always ends up spluttering and cutting out. Any other area we can look at which could be causing this problem? Have you tried to see if the gas flow ...
...cuts for a few minutes, then begins to make noise where the engine increases in tempo, then slows, increases and then slows for what could be a couple of lengths of cutting, at some point it gets fed ...
85 questions posted
Usually answered in minutes!
370 Questions
122 Questions
64 Questions
42 Questions