...needs more choke, and the auto-choke should release when the motor warms and runs smoothly. If the choke is sticking, the motor will die when it gets warmed up, then start again after it cools
Question about Mtd Garden
MTD LAWN MOWER PART # 903-0382 AXLE Assembly: FRONT: cant seem to move stick to choke or idle postion i... Cant seem to move stick to choke or idle postion it semms to be locked You need to get some ...
Starts but almost immediately stops. Will restart but repeats stopping. Looks like choke reverts too soon. If this is a prime type carb then the carb need cleaned and a new needle and seat installed. ...
...choke up, sometimes just allowing it to run will flush it through. if not it could be you have water in your gas, your needle valve could be sticking or worst case it needs to be adjusted, in that ...
...choke asm... but more like the the throttle asm)... and noticed it was sticking. It released and then I tried the engine and it seemed OK. I then applied some lubricant to all the pivot points and ...
My Honda Generator is running too rich. sounds like a bad airfilter or a problem inside the carb or the choke is sticking closed
Question about Garden
...and almost stalls have to use choke to keep it running. After mowing for a few minutes the mower sputters and stalls sounds like the flowt is sticking in the carb and it need a carb rebuild ...
coke stays on lawn mower engine model 92902 type 5330-01 code 84013106 Your throttle cable may need adjusting or you choke arm is sticking
Question about Garden
...a deni PD24j? Not familiar with that machine but it sounds like the Spring to hold tension on the Choke Butterfly. Should stick up Vertically on the top of ...
choke is sticking in the closed position (great for starting cold) but it is not opening when you move the the dash-mounted throttle lever from START to RUN. You should be able to check that the choke
85 questions posted
Usually answered in minutes!
370 Questions
122 Questions
64 Questions
42 Questions