Question about Husqvarna Garden
...Engine does turn over but as I said no spark. Flywheel and ignition coil are located on the rear of this engine. Remove covers as needed to reach the ignition coil. There are two (2) High-Tension ...
spark engine has no spark. changed coil, spark plug, cleaned all parts deffently check for kill switch engaged or un hook kill from moyor and see if it sparks if does kill bail is engaged may be cable
...but not installed in the engine. The spark plug base should be grounded to the engine while trying to start and checking for a spark. If there is a weak spark, this is probably due to a worn
...engine is briggs and stratton 3.5 hp vertical pull the wire at the kill switch and retest for spark -if still none remove starter cover , pull wire off at magnetron unit retest if still none replace ...
...spark This is a new engine that is equipped with a brake control cable, which I assume is to kill the engine. No matter where I have that control cable, I have no spark. Jack Ohmstede there may be ...
...plug=same, no spark. Pulled the kill wire off the magneto (solenoid?) and still no spark. remove the top cover from the engine and remove the small wire from the coil if still no spark the coil is ...
Engine won't fire-no spark. New plug. Check stop switch mechanism (kill switch, safety interlock cable). Check for damaged coil wire to spark plug. Make sure coil wire is completely seated onto spark ...
...small wire at ignition module. Then check for spark. If no spark, replace ignition module. If there is spark, then there is a short in the kill wire or engine control cable is not adjusted
Question about Garden
...an electronic unit or just a coil? if electronic and you are cranking the engine fast enough and have the plug well earted against the cylinder with the earth wire not connected it should
175 questions posted
Usually answered in minutes!
370 Questions
122 Questions
62 Questions
64 Questions
42 Questions