...motor start Tested motor with 12 v battery and is fine. Replaced motor control board. When pressing start, there is a 5 second delay before the motor starts. Then, the motor jerks and sputters for a ...
...start the motor to move at approx. 1 mph if it does motor is good,if not you may worn motor brushes worst case open connection in the motor. Now if the motor is good then reconnection the leads and ...
...Motor belt wont start on a brand new Sole F80. Motor isn't starting at all . Initally when turned on the display comes on and it can be programmed but as soon as START button pushed there is a click ...
...Motor Connectors) by clipping on them and then pressing the start key you should have a DC voltage reading if not the controller board is defective. The motor can be tested by using a simple DC ...
MOTOR WONT START Motor wont start is new motor Please post the specific model # found on the model/serial# decal on the frame of the machine (EPTL....) Who replaced the drive motor on the machine, and
motor should start to rotate if not replace worn brushes. If the motor rotates then you may have a defective motor control board. To test this portion you will need a multi-meter place leads where you
...start on the treadmill a red light on the computer by the motor starts blinking and the treadmill does not move? hi check the motor connection first. may have possibility of motor controlling igbt ...
Question about Nordic Track Exercise & Fitness
start the motor. if that process happens then you need to check the motor Cordless drill battery- get a fully-charged, 18 volt (preferred) cordless drill battery and on most treadmills connect the red
...button the belt drive motor is trying to turn but can't. I attempted to run on the belt while the motor was trying to start but that had no effect on the motor. HI, please replace the control ...
Question about Proform Exercise & Fitness
...I would first start with disconecting the motor leads and see if it trips the breaker. Then elevation motor would be next if no change from disconecting motor. More than likely it's a motor
50 questions posted
Usually answered in minutes!
346 Questions
56 Questions
48 Questions
44 Questions
