...step off it runs fine. so i tightened the belt just a fraction and now works fine. check your instruction manuel it will explain how to do this. normally its two screws at the backend of the roller. ...
Question about Proform Exercise & Fitness
...until I step on it ........then as soon as I step on the walking belt the belt just stops while the machine says it is still running........pulling off the cover.....the choke starts getting hot and ...
I have a proform xp 550e trademill and i changed the motor control board because the motor start running and inmediadlly stops. after i installed the board the motor start running and stop some time ...
Question about Proform Exercise & Fitness
...runs fine until you put your weight on it. Once you stand on the treadmill with the belt running it gets stuck? This condition is when the treadmill operates normally without a person on the belt and ...
...faulty. and step on until you elminate the short USE the DVOM or VOM. g)motor h)board mainBefore to do something RUN THE software calibration for diagnose, troubleshooting, and fix it.God bless ...
...step the treadmill seems to stop. It seems loose. To tighten the belt, start by locating the two bolts that adjust the rear roller (one on each side of the unit in the back). Run the unit at about 3 ...
I currently replaced the walking belt on my C954i/C956i treadmill. When I plugged it back in and turned on the power, the treadmill has no power. What could have happened? Dear Sir: I can read you ...
Question about NordicTrack Exercise & Fitness
I have a nordictrack a2350. The belt runs fine until you step on it. How do I fix this? the walking belt may be loose. adjustment screws are at the back of the walking belt. one on either side
...runs fine until i step on it then it stalls and stops running There is a motor which spins the treadmill belt.When you start the treadmill, the motor starts running and belt spins smoothly.But when ...
Step 2.2 Remove the key from the console.3 Unplug the power cord.4 Remove the screws from the console hood and remove the hood.5 Turn the pulley until the reed switch and magnet are aligned with a 1/8
42 questions posted
Usually answered in minutes!
36 Questions
38 Questions
9 Questions
4 Questions