Precor C966i Treadmill C 966i "speed sensor testing" Questions

...speed sensor. This could be due to the speed sensor being misaligned, improper connection, or bad speed sensor. Refer to the flowchart on page "SAFETY SHUTDOWN Loss of Speed Signal" or "L5" WITH NO ...

...speed sensor and change if is faulty. If LED does not light, inspect: 1. Optic sensor signal wires and their connections; Reinsert wire ends into connectors. 2. Whether optic sensor wheel rotates in ...

...sensor differs from the speed setting. Analysis: Optic sensor signal issue -- Either the optic sensor signal is not right, or it is read incorrectly, or the signal is not reaching the display. test ...

...speed sensor. see the diagram attached .This is probably a faulty speed sensor or the speed sensor is not plugged in properly. Its also possibly a faulty motor control board test the output voltage ...

speed sensor cable...did this and code remains?? Precor Error LS, Speed Sensor Signal Missing Probable Cause 1. Intermittent or open connection of the speed sensor (reed switch) wiring. 2. Reed switch

...sensor signal issue -- Either the optic sensor signal is not right, or it is read incorrectly, or the signal is not reaching the display. Adjust the Speed sensor according . Test for open or ...

...incorrectly, or the signal is not reaching the display. However test the speed sensor, for open or faulty. clean it, and tight the connector very well,ADjust it, see the diagram attached. God bless ...

...speed sensor signal was lost while the unit was in operation. Possible Reason: The line of sight between the speed sensor and the speed sensor target is obstructed. Incorrect gap between the speed ...

...signal is not right, or it is read incorrectly, or the signal is not reaching the display. Test the speed sensor. clean it, and tight the connector very well.see the diagram attached. God bless ...

Speed sensor of DC Motor treadmill making noise. The noise starts at 4.5 miles/hr, then goes away after 5.2 miles/hr; then starts at 6.4 miles/hr and stays up till max speed. How can I resolve the ...