...the treadmill does not work make sure to check the connections for the console that is responsible for sending the signals to the motor so if it has no proper connectivity then it wouldn't
Question about Life Fitness Exercise & Fitness
my 9500 next generation treadmill elevation not working Usually its the display panel not sending the proper signal - look under the display panel on the left side if standing on the belt, there is an
...error 1 is many times a speed sensor error. Make sure the speed sensor is in place, working and sending signal to the motor control board. I get a 51 code on the treadmill, I think the relay is ...
Question about Proform Exercise & Fitness
...to make the connection are seated firmly then reinstall the batteries, unless the function pad is sending a phantom signal engaging the display to be on continuously,or by pure chance the upper ...
Question about Epic Exercise & Fitness
...sending drive signals to that lower control board via a damaged or bad part, like I see on the Series 7 units... B). Lower board relay(s) or Triac(s) have failed somehow. Both situations can be fixed ...
Question about Proform Exercise & Fitness
...and change speed without fluctuation and the belt does not stop. Then the speed sensor is working, sending a signal that is reaching the processor but may have some op amps that are defective in the ...
Question about Nordic Track Exercise & Fitness
I have a A2105. When I turn on the power it starts by it shelf runs on 1 and when I run on a higher speed after a while it goes back to 1 I have check the #1 plastic button not touching the switch , ...
...to it flickering but the belt still does not move then we know the problem is with the controller sending the signal to the walking belt, in which you should check the wires that go to the motor.
Question about Nordic Track Exercise & Fitness
...sending odd signals to the MCB, or motor control board, or 2) more likely, the MCB has a fault(s) causing the constant lift/decline. There is usually a protection circuit which allows ONLY one ...
My treadmill Proform Crosswalk 400e stop, speed level from 1-6 and 8 as well as decline function does not send a signal and the belt does not work. nevertheless with function #7 the belt start runing.
65 questions posted
Usually answered in minutes!
346 Questions
56 Questions
44 Questions
33 Questions