...belt is tight enough then pull the front cover off and check the front roller. Sometimes the plastic drive pully slips on the front roller. If it only stops while you are running and is fine when you ...
Question about NordicTrack Exercise & Fitness
... I can get off of it and it will start again, this is a continuous problem. check mtr dr belt being loose-if tight, mtr demagnatized due to speed fluctuating on console,friction with walking ...
Question about Nordic Track Exercise & Fitness
...tight Belt stops when I get on it. Checked drive belt it is tight. 1) Try to loose a little the drive belt, for to avoid a higher tension.2) LUBE very well the deck belt, must shure is worn, proceed ...
Question about Proform Exercise & Fitness
...belt is too tight and that is contributing to the slippage. It should be loose. The general "rule of thumb" I have seen in the literature is being able to comfortable slip 2 fingers under the belt on ...
...check the belt to see if it is still slipping. If it is then tighten the belt 1/4 turn again. Continue until the belt does not slip, but do not tighten the bolts more than 2 full turns. If it takes ...
Question about Reebok Exercise & Fitness
...Check out belt slipping instructions or with the motor cover removed,walk on the belt normally and try to stall the belt to make it slip. Be careful during this test. If theproblem is in the drive ...
Question about Epic Exercise & Fitness
...Check the breaker from your home and reset.2)Inspect the wires from your outlet in the wall and tight it.3)Do not use any extension cord!4)Examine the power cord and see if some wires is loose ...
...check the follow:1) the belt drive motor is faulty. 2) loose tension in walk belt, tight it.3)Roller bearing from walk belt is faulty(lack of lubrication) both extreme.4) Walk ...
The belt on my treadmill is folding. I have tried loosening the treadmill belt. Check if it is torn or not tight. Likely it stretched. Either way it needs to be replaced if it is not loose.
the belt is slipping and the treadmill is only 1 month old hi, may be the belt tightening roller become loose check it and tight the belt ok
52 questions posted
Usually answered in minutes!
346 Questions
56 Questions
48 Questions
44 Questions