Onkyo TX-8511 Receiver "protection circuit" Questions

...protection circuit itself can also fail. It is impossible to diagnose over the internet, and testing must be done at the circuit level to trace the cause. Cold solder point. 99.9% I have found cold ...

...protection circuit is activated to protect your speakers from a shorted output IC or output transistors. If there wasn't a protection circuit then the shorted output would send it's operating voltage ...

...supply proection circuit or possibly an output overload protection circuit. Have you disconnected the speakers and all other source inputs and outputs to verify if the unit still goes into

protection circuit, so to prevent further damage. Check the speakers and speakers wiring, a contact in speaker wires, or faulty speakers can send the unit in protection. Try unplugging power cable for

protection circuit, so to prevent further damage. Check the speakers and speakers wiring, a contact in speaker wires, or faulty speakers can send the unit in protection. Try unplugging power cable for

...protection fault condition. The fault can be your output drivers- the MOSFETS/IC's fitted for both the channels, Use a meter after disconnecting to check for short in the drivers. Disconnect the ...

protection circuit, so to prevent further damage. Check the speakers and speakers wiring, a contact in speaker wires, or faulty speakers can send the unit in protection. Try unplugging power cable for

...protection circuit on my yamaha rx 600d amp anyone with a clue whats needed to fix? Hi friend,when something goes wrong in the output of the amplifier the protection circuit take place to prevent ...

protection circuit, so to prevent further damage. Check the speakers and speakers wiring, a contact in speaker wires, or faulty speakers can send the unit in protection. Try unplugging power cable for