Brother PE770 Computerized Sewing Machine "needle bar" Questions

...Needle Bar slowly. I can't find anything about a needle bar in the instruction book about a Needle Bar. Just turn the hand wheel. The needle bar is the round bar that the needle is inserted into and ...

needle bar is ok. there's two mark at needle bar, the upper one is for height of needle bar: bring the needle bar at lowest position and in this case the upper mark must be equal with lower needle bar

...needle bar up until you see a block with a screw in the middle of it.bring the needle bar down useing the handwheel to its lowest position loosen the screw and you should be able to move the needle ...

Needle bar frozen I have a Brother SE-400 where the needle bar is completely seized. I was sewing, ran over a pin, and my machine just stopped. The wheel would not turn at all. I removed the plastic ...

...help. Nita guess one is your needle bar and the other is your presser feet bar, your needle bar would have a slot for the needle at one end & a needle clamp to lock the needle. Hope this can

...needle bar Needle bar is loose...you can take fingers and it will wiggle up and down Hello Doris Bentono Needle bars have two screws: one to tighten the needle in place and another on the opposite ...

...needle bar then turn on. The presser foot seems to be up. I dont know what the needle bar is. Please help? The needle bar as the long vertical bar that the needle is attached to. Hand rotate the ...

...needle bar. There are two very small wedges in the needle bar that when they come loose will not allow you needle to stay in the needle bar. They jam the hole. You can take you machine to a Paff ...

...NEEDLE BAR POSITION TURN STITCH REGULATOR TO LARGEST STITCH, THEN TURN HAND WHEEL TIL' NEEDLE IS ABOUT TO ENTER NEEDLE PLATE. AT THIS POINT THE FEED DOGS SHOULD BE JUST AT OR JUST UNDER PLATE. IF SO ...

...needle bar has been pushed up and is out of adjustment. You need to take off the side cover, there should be a screw on the back of your machine holding it on. Remove this screw, and remove the ...