Question about Behringer Audio Players & Recorders
...connect to a mixer The rule of thumb is you control your audio on the low side. That means you plug your mics, tuners, audio sources into the pre-amp and then the pre-amp into the equalizer/mixer ant ...
...connect my PA system. The following items I purchased are listed below: 1 PV900 power amp 1 PV115 2-way passive speaker 1 PV14 mixer I understand the basics and the order in which they should be ...
...Thank you The 'problem' could be anywhere in the chain - amp, mixer or speaker. YOU need to do some swapping to isolate which product failes. Swap channels, inputs and outputs and
...powered mixer. I want to join them together to power a loud pa with subs and speakers. Can I join these two heads togther somehow? Hi, If you have small electronics knowledge this might help you. ...
...powered mixer. can i set it to be a passive mixer? NO. It is a powered mixer only - although there is nothing to stop you turning the master volume control down to zero (even so I would still prefer ...
connect as follows. 1-preamp/mixer-------equalizer/reverb unit------amp-----speakers(keep all equalizer control to 0db). 2-check your cables for good connector no touching of any inner wire to chassis
...speaker sockets, u can connect the pre amps RCA output to ur power amps input. there will be seperate connector for speaker connection in ur power amplifier . You didn't specified the make and model ...
Question about Peavey Audio Players & Recorders
...powered speakers, connect those speakers to the MAIN and MONITOR outputs on the front of the unit with 1/4 inch INSTRUMENT rated cables (NOT speaker cables). To safely leave the power amps in the ...
...speaker (whether you changed the balance or not). Slightly worrying, any ideas? thanks Matthew Hi There, you need to eliminate all the connection and surplus items around the SUV-460 amplifier to ...
19 questions posted
Usually answered in minutes!
147 Questions
75 Questions
19 Questions
12 Questions