Question about Konica Minolta Office Equipment & Supplies
...IDC sensor failure.Wipe clean the surface of the transfer belt if it is dirty with a soft cloth or change the transfer belt unit is damaged.Reinstall or reconnect IDC sensor shutter or connector for ...
Question about Konica Minolta Office Equipment & Supplies
...IDC sensors are located under the transfer belt on the right sid eof the machine. Belt must be removed to clean sensors. Once belt is removed sensors are located on a black plastic frame and have ...
...run tcr gives error code 6. machine says operating,but does nothing. Check the following , Dirt of IDC sensor, Clean up the IDC sensor, if no then Printer control board abnormality Replace ...
...IDC shutter solenoid (SD3) Remove the black (K) Drum. behind and toward the front is a silver/chrome looking thin bar with a tine square that square is a sensor clean it or replace the drum (switch ...
...IDC/Registration Sensor in konica minolta bizub c450 Clean them located under the transfer belt when it is removed. after which you need to accurate the sensor cover protectors manually the clean the ...
...IDC/Registration Sensor in konica minolta bizub c450 Sir/Mam Clean them located under the transfer belt when it is removed. after which you need to accurate the sensor cover protectors manually the ...
Question about Konica Minolta Office Equipment & Supplies
...and see weather code is changing .if it is changing the drps board is the culprit. 2) clean the HV contacts located behind the processor unit. 3)clean the IDC Sensor unit 4)change developer ...
Question about Konica Minolta Office Equipment & Supplies
...IDC/Registration Sensor in konica minolta bizub c450 Remove the transfer belt. Then right below the fusing unit right where the edge of the transfer belt is located when normal installed right below ...
Question about Konica Minolta Office Equipment & Supplies
...C-550 I appear P. -21 code After I changed the UNIT appeared to me Code P. -5 What should I do Clean the Front and Rear IDC sensors,open and close the front door,run an image stabilization
clean the IDC sensor located under the transfer belt forward section (right side of the copier) the rear one towards back of the machine right side There are two clean both Above two codes should then
208 questions posted
Usually answered in minutes!
1,023 Questions
924 Questions
417 Questions
321 Questions
302 Questions