...replacing the power supply board only get 50/50 chances for the tv to work.Might be the problems,might not be the power supply board issue alone some times.The chances are tv Tuner signal board is ...
...power main board needs to be checked and replaced --------------- if there is sound but no picture and front led light is blinking then its inverter board panel problem.if this is your case replace ...
Question about Protron Televison & Video
...the 2 long LCD inverter board will get ur picture back.If power dies than buy the power supply board for the replacement.The power supply board is the board where the power a/c cord plug into
...power supply fix it Physically disconnect the SU board and the SD board. (See precaution # 5) Plug in the TV and turn it on. Does the TV shut down and the power LED blink 7 times? Yes No Replace the ...
Question about Philips Televison & Video
...fired right up. Your best bet is to replace the power board. You will have better luck on replacing to board level vs. component level. does any body know the value of the three ...
Question about Sharp Televison & Video
...power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board ...
...correct meters and equipment it can get exspensive replacing boards however it almost has to be located on the power filter or the power board. I would suggest the power board over the power
Question about Televison & Video
Power Supply board that control LED ON?) Picture image is visible using flashlight method. (Therefore T-Con and video portion of Main Board are probably OK.) Voltages on CON2 on the Power Supply board
...replacing the power board? In the main board, there are test points, but normally no repair can be done with these board, other than replacement. If you wish to get some details, ...
Question about Element Electronics Televison & Video
...Power Board. Can the Power Board cause this Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some ...
70 questions posted
Usually answered in minutes!
194 Questions
156 Questions
51 Questions
56 Questions
53 Questions