...DVR remote to get into the "more settings" option. 7. Find audio settings and choose HDMI output, press select. Hope that helps......... Dear Sir/Madam, Make sure mutes is not "ON" mode. Within 30 ...
...dvr/vcr button and stand by button simultaneously. This would erase all your assignments so you would need to reassign all your sources hooked up to your onkyo. check your setup: *press setup *go to ...
noise is output protection in that case you must return where did you buy for service and update firmware a lot of update However you can reset your receiver and debug the DSP section ( digital signal
noise that can overload things and cause the protection circuit to trip again). If you can see the display, go to a low level (around -50dB should be fine) before the delayed speaker amp output clicks
Question about Yamaha Audio Players & Recorders
...noise that can overload things and cause the protection circuit to trip again). If you can see the display, go to a low level (around -50dB should be fine). Then carefully switch back to the problem ...
...DVR button, then press ON/STANDBY button. Make sure you write down your current settings, so you can easily go through the setup after resetting. Not a solving of the problem, just not sure how else ...
...DVR button; press STANDBY/ON button; "Clear" should be displayed; unit will revert to Standby mode. For a firmware problem, you can always have it updated. Pls reference this page for additional ...
Question about Yamaha Audio Players & Recorders
noise from all speakers...the only input i have currently is digital from dvr. ive checked the dvr audio settings and theyre all fine. my main concern is the speakers not showing up on the front panel
93 questions posted
Usually answered in minutes!
192 Questions
173 Questions
140 Questions
146 Questions
92 Questions