...drum wiring ,remove belt (note position) remove motor &, lay to one side, withdraw nylon pins from shock absorbers, Look for and remove the little earthing cable set just inside the pulley rim. ...
...remove the entire drum through the top of the appliance, but before I start a couple of questions. Can someone give me a quick sequence of actions? Can I do this job without a bearing puller/ any ...
...remove the drum start at the front remove front panel,four screws 2 under front,1 behind soap drawer and the one near the filter,next take door off 4 spring clips on the next panel plus screw on door ...
remove drum pully, refit pully bolt and drift inner drum out having put nut back on drum spider thread to avoid flaring shaft, using hammer knock shaft through bearings, then using a chisel or similer
Remove the drum from the machine, remove the washer drum, knock out bearings, replace drum spider (shaft) fit the new bearings, and drum seal, put everything back together again. Job for a experienced
...drum is easier as it has a 'spider asssembly'. remove this after taking off the pulley by taking out the bolts that hold it and bang it off being carefull of the heater element. remove the bearings ...
...remove the drum from a Hotpoint WM64 washing machine? I need to change the bearings. Remove top cover and rear panel. Remove belt and drum drive pulley.Remove clamp that secures door seal Remove top ...
...remove the hex nut whiled drum on the frame because it is easy to remove while it is on the frame. 2. Take the complete drum assembly out of the washing machine frame. 3. Leave the drum assy on a ...
Question about Washing Machines
have to remove the rear panel and drum pulley to access the drum . shaft and bearing housing. Then depending on the set up, you will have remove whatever screws there are to remove the bearing housing
Question about Zanussi Washing Machines
remove the drum? Yes you do need to remove the drum, it entails stripping the washer down, and it is normal practice to replace the complete drum half with the bearings pre-fitted.. It is not a job to
1,103 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions