...error won't go away. Try unplugging the power cord from the electrical source, IF it has a power button, hold that down for 30 secs, plug back in, turn on. Also check for any small particals that may ...
Question about HP PhotoSmart Office Equipment & Supplies
...error oxc18a0301 Perform the normal assert troubleshooting: -turn ON the printer -disconnect the usb cable from both ends of the printer and pc if printer is connected with USB cable -open the ...
contribute to a printer cartridge error report. Take note that the cartridge should not be left open for more than 30 minutes; otherwise the ink will start to dry up and the cartridge will get clogged
Question about HP PhotoSmart Office Equipment & Supplies
new, printer says replace. what should cartridge new, printer says replace. what should I do? Unplug printer AND USB wire. After 30 seconds, plug everything back in. It should clear any error messages
Question about HP PhotoSmart Office Equipment & Supplies
...error 1) connect printer directly to wall 2) try different walloutlets 3) remove the ink cartridge and then clean it with a lint free cloth.. clean the printheads as well. 4) the unplug the power ...
Question about HP PhotoSmart Office Equipment & Supplies
contribute to a printer cartridge error report. Take note that the cartridge should not be left open for more than 30 minutes; otherwise the ink will start to dry up and the cartridge will get clogged
error message that says to use the power button don't unplug to prevent errors ect. then it reboots and keeps going in this loop... Any advice? Follow the steps below to power cycle your all-in-one: 1
Question about HP PhotoSmart Office Equipment & Supplies
error 0x887 dd03a does anyone know what this means? Take out both the cartridges from the unit. Unplug the power cord from the back of the unit,without turning it off first. Take out the USB cable, if
...error oxc18a0206 Unplug power cord from printer and electrical outlet wait 30 seconds and hold in help and OK buttons while reconnecting power cord. continue holding buttons until screen turns black ...
...error 000FBB6 followed again by a blank screen message of "Turn off power, then on again" and when I click the power button to turn it off, it just stays on and goes through the cycle again. Hi, Try ...
835 questions posted
Usually answered in minutes!
1,869 Questions
1,438 Questions
900 Questions
484 Questions
508 Questions