Needle shaft stuck. Machine won't work. Needle shaft stuck. Have removed bobbin and bobbin case, needle, foot. cleaned, oiled but still stuck. Cannot move round turning thing on far right. How to fix?
...jam when running the machine, the part under the plate moves and hits the needle making it impossible to sew stuck the whole machine the needle did not move .needle and wheel handle both are ...
...needle out? The machine is a Juki DDL 555 Thank you check settings use a pair of side cutter plyers and snap the needle sideways till it breaks or just cut it. watch eyes cause it will fly since ...
Question about PfaFF Sewing Machines
...needle from pfaff machine why is bobbin not working Where is the broken needle stuck? The broken upper part should just come out like a regular needle (via the needle-screw). If the broken tip is ...
...machine. The needle is stuck and won't go past the needle plate. It had just hit the needle plate and the needle was bent, however I replaced the needle and now it will not go past the needle ...
...foot is stuck in down position so that needle is under plate of machine. Cannot lift it with handwheel. It is stuck in down position. sounds like the machine froze up, machine needs to be ...
Question about Juki Sewing Machines
...machine? While I am sewing, the needle frequently gets stuck below the guide plate and the only way to get it loose is to remove the guide plate. How can I permanently fix this problem? If the needle ...
Question about Necchi Sewing Machines
machine needle is stuck and the machine will not move. I am hemming a pair of jeans and the needle got stuck and now the machine won't move. I think the needle is bent or broken. What should I do? you
...needle gets stuck run the machine without fabric and thread and see what happens, if the needle get stuct you may need to retime it, if it only gets stuck when you are sewing make sure you are not ...
Question about Janome Sewing Machines
...machine incorrectly. Make sure the needle is in correctly with the flat side to the rear of the machine, make sure to thread the upper and lower portions of the machine correctly. If this does not ...
743 questions posted
Usually answered in minutes!
193 Questions
102 Questions
90 Questions
79 Questions