is an older mechanical machine, they may be seized due to old oil. Wheel on right side that controls the needle up and down is very tight... Or, the feed dog mechanism is broken. This is a repair site
Question about Sewing Machines
...on its mechanical parts. If nothing else, try directing hot air from a handheld hairdryer into the internal mechanism where the feed dogs are to see if that loosens it up. Bernina 1008 feed dog ...
...feed dogs are mechanically connected to shuttle race link.everytime shuttle race rotatate and needle goes up and down the move relative to its timing order.there is control knob on feed dogs to ...
...back and up and down at full stitch length? Or can it be that the regulator knob is slipping and not adjusting your feed mechanism? visit my site ...
...and I have to pull the fabric through, the feed dogs move up and down but not forward to feed the fabric it would be a good idea to have the feed dogs checked to see why they are not moving the ...
Question about Elna Sewing Machines
moves due to the action of the feed dogs. First remove the fabric from under the presser foot. Check for tangled thread wrapped around the feed dogs or fabric/thread going down into the bobbin area in
...feed dogs in the needle plate are what moves the fabricto be sewed, the feet only hold the fabric against feed dog so themachine can use the needle to sew the fabric.if the fabric is not moving then ...
mechanism to drop the feed dogs for darning? Many sewing machines have a mechanism (a dial or switch of some sort) which allows you to drop the feed dogs so that you can do darning. When the mechanism
Question about Sewing Machines
...mechanism on the machine. Try leaving the foot up while you run the machine, you should see the teeth going up and down; if they are it is most likely just a case of setting up the amount of pull. I ...
Question about Singer Sewing Machines
...feed dogs for darning. The feed dogs need to be in the "up" position to move fabric.
Also, be sure that the stitch length is set to something around 2 or 2+ which would allow the feed dogs to ...
125 questions posted
Usually answered in minutes!
111 Questions
75 Questions
56 Questions
44 Questions
29 Questions