...between it and the belt. pull it out, take the back off and see if something is caught or if you can turn the shaft. If the shaft seems hard to turn, most likely it's the motor breaking down in
Question about Whirlpool Washing Machines
...breaking the motor coupling can you help This is often a worn clutch or broken t-bearing support. If the t-bearing support or ball cracks and breaks or comes out of place the clutch will ...
...washer is a Gibson top load I have the trans bolts loose in the tub and the 6 innner tub bolts as well. The outer tub springs have been taken loose but the tub will not come out.? I srayed some ...
...torque (Maytag Performa PAV2300) I took the transmission out and noticed that I can turn the lower shaft cw (with the thrust bearing assy) and the upper shaft goes through the agitation movements. ...
washer ) on the side of the outer tank is also bad for leaking. See #'s 16, 17, 18 for the button catcher, grommet and clamp. Replace them all at the same time, the grommet is glued as well as clipped
...shaft from the washer drum I am replacing my transmission of my 25year old inglas washer, i lossen the transmission, but the shaft is locked into position with the drum, how do i remove the shaft. 1. ...
Question about Crosley Washing Machines
...edge of the cabinet. Look for broken pieces on the floor. See if you can freely rotate the motor shaft without affecting the transmission shaft. Check that the transmission shaft can be turned by ...
washer and it will not come off, the washing machine will not spin so this is why i'm pulling the pump off, what do i need to do If the pump has been slowly leaking it will be stuck to the motor shaft
...washer needs replaced; now that i have the part, i began to replace it, but the existing one is not broken; is it the problem? Was the motor working before, but no spin action. Make sure the plastic ...
30 questions posted
Usually answered in minutes!
992 Questions
874 Questions
371 Questions
398 Questions
323 Questions