Question about Candy Washing Machines
...words correctly, when you turn on the washing machine it immediately causes a fuse to blow out or a circuit breaker to flip off. If this is so, please do NOT turn this machine on again until the ...
...the switch? pull the end caps off the you will see 2 screws take them out then the council you can flip it back you then will see 2 clips to remove and a wire plug then the whole case will pull for ...
...flip this thing over to do this??? Or do you just pull up? I dont dee any bolts or anything inside...Do I just go to lowes for feed dogs? Thanks! Tiffany that's funny [feed dogs]they are called, dog ...
Question about Kenmore Washing Machines
...for an easier place to watch for the leak. If this machine was purchased after 1988 the console flips back to reveal 2 gold clips. disconnect the lid switch connector and remove the cabinet. The ...
...washer had two screws behind the cap and once removed - it was just like the video. The cap flipped up and with the wires disconnected, two large clips removed, the body lifted, slid forward ...
...words, if you get behind the washer, and look at the top (behind the control panel) near the side, you'll see two screws (one on either side) that attaches the control panel to the cabinet. ...
Question about GE Washing Machines
...words, the washer things the tub is too hard to move because it's overloaded and the motor is struggling. The most common problem is a nut below the inner tub that needs to "float". Floating is when ...
...flip the console back to its resting position over the machine back panel. Be careful not to break the small plastic hinges that hold the console in place. 2. With the console removed, look for two ...
1,338 questions posted
Usually answered in minutes!
874 Questions
371 Questions
398 Questions
323 Questions
255 Questions