...Mixing valve bad? Recently had hot water heater replaced. Trash in line blocking valve? I would pull the lines off the back and check the inlet filter on the hot and cold sides of the water inlet and ...
...bad water mixing valve or bad water level switch. The pump : The pump job is to remove the water from the tank to the drain pipe. This pump has an electric motor and an impeller. When the pump motor ...
bad mix valve -- the mix valve is the small plastice valve that the two water hoses connect to on the back of the machine. turn off the water lines, and remove the two hoses, now remove the back panel
...mixing unit is leaking. You can take a look at item 39 below, it is the water valve unit. There could be a piece of rust scale or dirt under the valve seat that is causing the leak or it is just worn ...
...bad / stuck mix valve --- the mix valve is the plastic part that the hot/cold hoses connect to on the back of the machine,, remove the two hoses..remove the back panel and the valve is held in place ...
hot or cold water,no warm water does not mix bad mixing valve
...the water valve it shuts down,so it is beeing commanded to come on fromt somewere,the question what is commanding it all the time You could have a bad mixing valve. I would suggest
...cold water from entering,or more likely the mix valve has gone bad (the cold water solenoid) replacing the mix valve is not hard on these for a doit your selfer and the parts are less than $ ...
cold water not coming on in cold mode if the hot and cold are switched will it make the mixing valve go bad? or only give hot water? YES.Just replace the valve.it comes in one piece.
Question about Washing Machines
...to bottom machine leaks from top always have 3 lines coming down the front between the lid and the boby. The water mixing valve is gone bad, replace valve this should stop problem Hope this may
401 questions posted
Usually answered in minutes!
992 Questions
874 Questions
371 Questions
398 Questions
255 Questions