...gas flame seated correctly on orifice port.Gone was the unburnt odor of natural gas. The typical flame in a flame appearance now was exhibited by the small pilot,secondary pilot remained consistent ...
Question about Heating & Cooling
...goes out Try cleaning the pilot out sounds like flame is too small and when main burne rlights it takes gas away from pilot .Clean pilot try blowing it out with can of air or with air line carefully
...pilot flame and it sends a low voltage flame to the gas valve to open the main gas flow valve. they are very easy to install and they are located next to the pilot burner and screw into the gas
...gas flame appliance is connected in line with other appliances to a 500 gal tank, pilot lites and stays lit; but, when I turn on gas, flame comes on for a little while and then pilot goes out , flame ...
Question about Heating & Cooling
the flame is hitting the thermocouple which should also be cleaned. If after a minute or two the pilot light still will not stay lit then it could be a bad thermocouple or the gas line pressure is low
gas valve? If so increase the flame. Has it always done this? If so, is the model made for the specific gas being used i.e. Natural Gas or Propane and it may be operating on the wrong gas? Let me know
Question about Williams Heating & Cooling
...is some sort of gas in the chamber that's so strong, it prevents flame... and the only thing I can think of is that it doesn't have enough oxygen, but too much natural gas, and flame can't
Question about Uniflame Heating & Cooling
...pilot goes out and no flame. pilot will light again. Plenty of fuel in the tank. You have a white scale buildup in the gas valve outlet blocking the main gas flow. Take the valve apart and clean
...gas valve. If the flame changes colors and lifts from the burner, that is a sign of a plugged vent. Good luck. Therinnaiguy - Thanks for the response and I have a follow up comment adn question. I'm ...
Question about Heating & Cooling
flame of the pilot, and the heat generates a small electrical current conducted back to the gas valve, keeping the pilot gas line open after you switch it to the "on" position. That's why you have
362 questions posted
Usually answered in minutes!
2 Questions
1 Questions