Leisure HOMEPRIDE Electric Fireplace Heater w/ Remote "flames working" Questions

Ad

Question about Heating & Cooling

1 Answer

lennox intermitent flame problem I have a lennox furnace without a pilot lite, it will glow and the flame will start and then shut off immediatly, sometimes it works fine and then it has problems. The

Ad

Fire was working fine, then flame effect stopped. Heater still works on both settings, but no flame effect. Tried new bulbs, but still no flame effects, any ideas? Dimplex jaz20 optiflame electric ...

Ad

Question about Coleman Heating & Cooling

1 Answer

...sure the tip of the thermocouple is not burn't off, which usually happens with lazy yellow pilot flames. Replace thermocouple is nothing else

Question about Goodman Heating & Cooling

1 Answer

GMH95, FLAME SHUTS OFF AFTER A FEW SECONDS Flame rod dirty or bad, flame tray not allowing flame to travel to all burners quick enough, look for error codes on PC Board and research code from wiring ...

...teh rollout sensors are, but the unit still works. Sounds like you may have a major issue. If the flames are not going into the heat exchanger there is a possible crack that is pushing the flames ...

Question about Dyna-Glo Heating & Cooling

2 Answers

blue flame heater pilot wont stay lit pilot wont stay lit flame wont come on There is a therma-couple that the flame burns against. When it is working correctly it allows gas to travel to the flame. ...

Question about Goodman Heating & Cooling

3 Answers

GOODMAN GAS FURNACE. IGNITOR GLOWS, GAS FIRES FOR 3-4 SECONDS THEN SHUTS OFF..CYCLES OVER AND OVER. SOMETIMES IT STAYS ON...THEN SHUTS OFF BEFORE TEMPERATURE GETS UP TO THE STAT SETTING... I suspect ...

Question about Heating & Cooling

1 Answer

...type of gas heater you have as there are a range now and some work as following and some have two flames which is the pilot flame and the main burner flame. The pilot flame is what the thermocouple ...

I've got good flame replaced Powerpile pilot won&#t stay lit I replaced the whole pilot assembly an powerpile on a cozy floor furnace The flame sensor is not producing enough volts to hold the gas ...

RPJ 2 Comfortmaker. Turns on, runs for 5 seconds with flames then turns off. Sensor light blinks 6 times. Diagnostic instructions say check service instructions. What's wrong? on opposite side of ...

Not finding what you are looking for?
Heating & Cooling Logo

362 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Leisure Heating & Cooling Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Paul Carew

Level 3 Expert

3808 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Leisure Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...