GE JVM3670 Microwave Oven "special screwdriver" Questions

How do I get the special screws out of the back of the Cuisinart microwave bottom. with a special / security screwdriver

...turn table turns but does not heat. what part is needed and special tools? Possibly door catch and/or door interlock switch may be damaged. No special tools are required, maybe a torq 20

...special tool (screwdriver) to get the cover off to replace the fuse. Where can I get the special tool? Is it like this? If so, there are several ways to loosen them: Some folks just use a hammer to ...

...up but not sure where to start and it looks like I need a special screwdriver. theat screwdriver available at any leading tools sales shop. check the door open liver and may be that lever

...or detached from anything. Is there a special type star screwdriver required to get it out? The screw heads on rear of GE microwave is special, what do i need to ask for to remove them. Thanks ...

...special screwdriver heads. It has what looks like a hex with a tip in the middle. Also can you advise where the the main fuse inside is located and can I test it with an regular v/ohm meter? You can ...

...special screwdriver? Some models use an tamper-resistant screw which can be removed with a specially-designed tool available from home improvement stores & appliance parts stores. But some folks ...

...special screws on the back...a phillips or screwdriver don't work on these screws...any ideas on what type of tool would remove these screws? Probably a Torx, square or star driver or bit. A very ...

...special toll but i can not find this tool You can usually remove anti-tamper screws using a T20H Torx type or GTXH20-100 screwdriver. If the correct tool is not available, there are several ways to ...

...special screw head but if you jam a small flathead screwdriver in you can snap off the tiny stud so that you can now use a star driver. (be prepared to damage the screwdriver head). The bulb can be ...