Question about DeLonghi Heating & Cooling
...is a pair of 6 cables that need to be unplugged from the switch before removing it; the cables go on the upper, middle, and bottom part of the switch. On top goes two black cables, and either on ...
Question about Honeywell Heating & Cooling
I can't get the thermostat to go past 82 degrees Go to myhome.honeywell.com Go to myhome.honeywell.com and search for a manual for your model number thermostat on the right hand side of the page.
rinnai 431wt filter light won't go out I cleaned filter and vaccuumed out everywhere I could think of and dirty filter light won't go out. Heater still seems to work okay other than that. If you have ...
how to hard wire 240 volt wall heater need to which wires go where ran a new line 4 wires 1 copper 1 red 1white 1 black where do they go help please ? Black is 120v hot Red is 120v hot Black and Red ...
The pilot light on my Deas heater keeps going out Pilot light is always going out on my Desa vent free stove. Cleaned the pilot assembly and it still is going out. Can you tell me what the milivolt ...
my heater is not running no ignition i have a good man furnace when i call for heat the draft motor runs for 2 seconds then a relay on the the board clicks and the draft motor turns off and the main ...
...phase because all heaters are single phase. It will require a larger feed because your amp draw is going to go up doing away with the third leg. You split the heaters up from 3 phase to 2 legs amp ...
Question about Carlton Heating & Cooling
...rocker switch for our Freestanding Electric Stove. It seems the CFM Harris Systems Inc. is going out of business and it was a dead end trying to go through them. ...
Keeps going out I have replaced the thermal couple and pilot assembly and it still continues to go out after 20-30 sec. when I turn it up. Is there anything else I can check? If you just leave it on ...
the oilot lite keep going out the piliteoilot lite keep going out Check to see if the pilot lite is going past the pin- (flame sensor) if not then your flame is too low , Clean the pilot oriffice or ...
86 questions posted
Usually answered in minutes!
10 Questions
8 Questions
7 Questions
1 Questions
2 Questions