Whirlpool Inglis IP8200 Dryer "thermistor resistance" Questions

thermistor resistance is around 10000 ohms (10K) at room temperature. Replace the thermistor if the resistance is significantly higher (or lower) than what it is supposed to be based on the resistance

...thermistor reads the correct resistance at room temperature, it could still be defective and giving a bad resistance reading at higher temperatures. If you suspect that the thermistor is good, check ...

...thermistor is a component whose resistance changes when its temperature changes. A thermistor is a special type of resistor whose resistance decreases as its temperature increases. A plot of ...

...thermistor resistance is too low, the control board turns off the heater relay. The problem here must be the control thermistor. Its resistance must be too low or even shorted thereby making the ...

...thermistor resistance values. Replace the thermistor if the measured resistance is not in the table. Check the wire harness for short circuit if the thermistor resistance is good and make sure the ...

...the resistance of the thermistor then refer to the temperature and resistance table for the normal thermistor resistance values. Troubleshooting Error Code E1 on Kenmore Elite and Whirlpool Duet ...

...table for the normal thermistor resistance values. Click on the link below for the detailed troubleshooting procedure. Troubleshooting Error Code E1 on Kenmore Elite and Whirlpool Duet ...

thermistor resistance values. Replace the thermistor if the measured resistance is not within range of the table. Check the continuity of the wire harness if the thermistor resistance is good and make

...thermistor resistance values. Replace the thermistor if the measured resistance is not in the table. Check the continuity of the wire harness if the thermistor resistance is good and make sure the ...

...resistance inside the thermistor will change in relation to the temperature. This resistance is then used by the electronics to determine what the temperature is in the area where the thermistor is ...