Makita 6935fd doesnt go into impact mode, just stops like a normal screwdriver. Both batteries tested 15 plus volts. any answeres? could be a problem with the impact hammer, I would suggest removing ...
Question about Dewalt Drills
...impact driver when in reverse works fine but when in forward it will work for a few seconds then stop and keeps doing that. why? I'd be looking for a defective forward/reverse switch, or a bad ...
Question about Makita Drills
...impact driver, I press the trigger and don't work, only the light come on,I replace the trigger but I still have the same problem. I would guess that you have a motor issue. It maybe as simple as ...
...impact driver and a 3/8" or larger allen socket. Chuck up the allen socket in the drill and use the impact to remove the chuck.Chuck is right hand thread so loosen ccw. Air impacts have a much higher ...
...Impact Driver only works at high speed On Friday while installing composite decking on a very small porch, I was using my 14.4V Makita cordless impact driver which was working great until I got near ...
my dewalt 10v impact just stopped working the light still comes on but not turning. was okay one minute then just stopped working Could be the brushes or a fault with the motor. Give it a little tap.
...impact driver keeps overheating brushes.After driving 1 screw the brushes are to hot to touch stops working. When drill cools it will work to drill one screw again. Sounds like a shorted Armature, ...
green flashing light i plug carger in put battery on it runs for about 5 seconds then stops then the green light starts flashing battery is open circuit or charger not working Re: Jeff
...impact driver stopped working. Now the tool spins to a stop instead of braking when the trigger is released. A local tool repair shop told me to replace the switch, but I want a second opinion before ...
30 questions posted
Usually answered in minutes!