Question about Audiovox Vehicle Parts & Accessories
...wire,i.e. some Subaru and GM cars and trucks. They can only be disarmed through data modules. More information on the year/make/model of your vehicle will be needed to accurately solve your problem. ...
Question about Autopage Vehicle Parts & Accessories
i try to start but the LCD shows engine stop 3 things to check: 1- Black/white wire (neutral safety wire) is grounded 2. White/Black wire (hood pin wire) is NOT grounded 3. That the remote start has ...
Question about Python Vehicle Parts & Accessories
...vehicle that shows the engine is running. The remedy for this problem is to connect the tach wire from the 533 a proper tach source. The other two causes occur when the smart tach feature is not used ...
Question about Autopage Vehicle Parts & Accessories
...wire from alarm was spliced to install power windows. Now car wont start. alarm works fine but the car wont start. You will need to diode isolate the wiring that was spliced. It is backfeeding into ...
If this is the factory alarm going off when you remote start the vehicle, the factory disarm wire is not connected. If you would list the year/make/model of the vehicle, I could direct you to the wire
...wire MUST be connected. Check the neutral safety switch as well. Did you install a clutch bypass? All that is left is the system setup for remote start: Start the vehicle with the key,make sure all ...
...wire diagram and find then test the vehicle wires. 7. connect RS/Alarm to vehicle, plug in antenna and shock sensor, then attach siren. 8. BEFORE DOING ANYTHING ELSE-GO INTO PROGRAMING AND CHANGE THE ...
vehicle starts and shuts down after 5 seconds. If so, the tachometer wire may have been disconnected during the repair service. The tach wire is green with an orange stripe and it may still be hanging
vehicle running. The ignition, accessory and battery wires should read 12 volts in the RUN position. This same group of wires should read 12 volts in the ON position. The ignition, starter and battery
...starting an stopping all three times 1,- Check the tag wire make sure is connect it or program the remote start to voltage check and you don't have to connect the tag wire. 2.- If the vehicle have an ...
58 questions posted
Usually answered in minutes!
360 Questions
288 Questions
312 Questions
218 Questions
215 Questions