...8 secs and then turns off. Are you going to charge me to answer my question? hi, Check the speed sensor near the motor pulley. If the speed senesor is faulty or dusty then the system contol ic in the ...
8 seconds then e1 flashes. follow this steps and fix it. See the diagram attached. God bless you ERR 1 - Motor Movement ERR1 indicates a speed issue. In this case, the motor speed as reported from the
...8.5. The unit will go to full speed so be careful not to be on the walking belt. The other number set should top out shortly at either 10.0 or 12.0 based on whether your speed buttons go up to 10 or ...
...8 in. (3 mm). If necessary, loosen the Reed Switch Screw , move theReed Switch slightly, and then retighten the Screw. Reattach the Hood , and run the treadmill for a few minutes to check for a ...
Question about Nordic Track Exercise & Fitness
...8 in.). If necessary, loosenthe Screw (27), move the Reed Switch slightly, andthen retighten the Screw. Reattach the Hood (notshown), making sure the screws are in the same holesfrom which they were ...
Question about Fitness Giant Exercise & Fitness
speed sensor between the front roller pulley and the frame of the treadmill. It is a small plastic piece approx 1 1/4? long and 1/4? in diameter with a black wire coming from the back of it leading to
speed, etc. The control panel does not acknowledge the buttons pushed. I've turned it off and on. my treadmill is doing the same thing. the only buttons that work are the start; incline up. 4 incline;
gap between reed switch and pulley.6 Replace the hood.7 Plug in the power cord.8 Reinsert the key into the console.9 Run the treadmill to check for a correct speed reading. This may take a few minutes
...speed, incline or a preset program Dear Sir>Adjust the reed switch , attached is the diagram for adjust it 1/8-1/4'2) Tight very well the flexible cables from keypad vs lower board.3) After ...
49 questions posted
Usually answered in minutes!
346 Questions
56 Questions
48 Questions
44 Questions