Chain saw stalls when engaging tree Chain saw will start readily, but stalls when applying chain to tree. if you have the and guard pulled back then it will stall.or if the chain is to tight it will ...
Chain saw stalls after a bout 10 minutes of operation. Will not Craftsman Chain saw stalls after about 10 minutes of operation twice during operations. FIrst time was able to restart. Now wll not ...
can I run an 18in bar on a 16in chain saw It won't idle or cut with out stalling you should be able to without issue. The Stalling issue started after lengthening the bar/chain?
Question about McCulloch Garden
MAC 7-38 chainsaw stalls when you open the throttle. Any ideas? It stalls when you open the throttle. Any ideas? We are talking about an electric chain saw ? I would say you are not getting oil to the
With the engine ticking over ,then when pull I the switch to run the blades the engine stalls. What is the problem. Hi. You have to increase the throttle to about half before you engage the blades ...
new husky t435, starts but stalls immediately. if i keep my finger on the throtle it stays going but stalls as soon as i release it. adjust up ur idle
137 stalls have a husqvarna 137 that starts and runs fine at an idel, but powers out, and stalls under load Sounds like an air leak somewhere. Or possible a clogged fuel filter.
craftsman chainsaw runs then stalls when starting to cut model 358351700. have not had it that long but it starts but as soon as a load is placed on it, it stalls. Is there a setting for this. I ...
husqvarna 55 idles but stalls with gas chainsaw will idle but stalls when increasing gas Most likely the diaphram in the carburator is bad.
Question about Husqvarna Garden
Chainsaw starts and runs for a while then stalls. It will restart right away run a few seconds and when used to cut stall out again Start by replacing the fuel filter in the fuel tank and try again.
520 questions posted
Usually answered in minutes!
529 Questions
514 Questions
353 Questions
122 Questions
131 Questions