Husqvarna , No.455 Rancher, 20" Gas - Powered Chainsaw "overhand knot" Questions

...overhand knot in the end. Thread the cord around the spool 4 times, then feed the end out of the cord port, slide the handle on, melt the cord end, tie an overhand knot in the end, and tuck the knot ...

...overhand knot in the end. Wind the cord around the spool CCW until most of the cord is used, then thread the end through the exit port and pull about 8 inches outside. Clamp the cord with locking ...

...overhand knot. Wind the cord around the spool several turns in the same direction as the old cord, then pull on the cord to wind the return spring inside the spool. Wedge the spool to prevent ...

...overhand knot in the end. Wind the cord CW until you have about 8" left--poke the cord out of the cord port, push the end through the handle, melt the end, and tie an overhand knot. Stuff the knot ...

...overhand knot). Thread the cord CCW until the spool is nearly full, then feed it out of the cord port and slide the handle on. Melt the end and tie an overhand knot to retain the pull handle. Release ...

overhand knot in the cord end. Feed it into the inner retainer on the spool, then thread the cord around the spool 5 or 6 times in a CCW direction. Once wound, feed the loose end out of the cord port,

overhand knot in the cord. Pull the knot back tight and proceed to wind the cord in a CCW direction around the spool until you have about most of it wound. Pull on the cord to wind the internal spring

overhand knots, but you need to melt the cord ends back a little so that the knots won't pull out (do the outer end after threading the cord through the handle). You have to wind up the spring so that

...overhand knot to retain it. Wind the cord CCW 5 or 6 turns, then thread the cord though the cord port, slide the handle on, melt the cord end, and tie another overhand knot to retain the handle. Hope ...

...overhand knot tied to retain both ends. If the cord is breaking along it's length, the cord may not be heavy enough--check with a local saw service shop for the correct cord and buy about 1-meter of ...