I have model # DGU10014ua, the red light blinks 4 times stating I have an open limit, sometimes the blower motor is not kicking on. How is the easiest way to get motor out of squirrel cage? and to ...
3450rpm motor how to check the over load swich MOTOR SHOULD HAVE A RESET BUTTON. IF U CAN FIND IT, HOLD IT IN-IF MOTOR RUNS RESET MAY HAVE TO BE REPLACED.MAKE SURE MOTOR DOES NOT OVERHEAT UNDER ...
ITEM: Dayton universal motor model 8mo38A 10,000 rpm spec number 6540 1.7 amps HP 1/5, Volts 230. PROBLEM: Motor used in small appliance with short on bursts and much longer off time but many cycles a
Question about Dayton Tools & Hardware - Others
can i control the speed of this motor with a ac light dimmer switch? no . with out getting to complicated the motor is designed to operate at 60hz witch is the frequency the voltage is delevered to ...
Question about Dayton Tools & Hardware - Others
Hi, I have a question about a 220v motor on a boat lift. The motor will operate fine in the down operation and will work fine when the boat is in the water starting up with no load. However, if you ...
Question about Goulds Pumps Tools & Hardware - Others
how do I change the motor side casing on a j5s pump It is a J5S Jet Pump with a crack in the casing on the motor side of the pump The motor must be dismantled as well . a bit scary , but I have done ...
Question about Electric Tools & Hardware - Others
I want to re wire an electric motor for low volt I have an electric motor that is 230 volt and the power source is 110. Can I re wire the motor for that voltage? Look on the name plate. If it says ...
...checks good, it's the motor. I bet it's a power supply problem though if you have two different motors with the same
Question about Leeson Tools & Hardware - Others
I have a 3/4 HP motor installed on my porch chairlift that has stopped working. The motor only hums when you push the up or down button. After removing the motor it spins freely and will run but has ...
motor with no labels motor burns wires 3 phase motors that burn wire have a short in one of the phase wires that is allowing twice much current pass than is allowed. I would remove it and have a motor
2 questions posted
Usually answered in minutes!
11 Questions