Question about Honda Electrical Supplies
Honda eb 7000 inverter generator won't stay running. It runs for 12 seconds and stops. I tried disconnecting the oil sensor but no luck. it appears to be insufficient fuel flow to the carby check for ...
...HONDA MAKES LOUSY CARBS: Remove the Carberator from the engine...You need to inspect it. Remove the carb bowl and clean it. Remove the Float and clean the valve seat seat. Blow thru the fuel flow ...
...carb bowl Engine Turns freely Any suggestions greatfully accepted check the needle and seat. also check to make sure that all your jets are cleaned out you need to probe them, honda are go for ...
gas getting into crankcase has new carburator Sounds like the float is not set properly or the needle valve is not seated properly.
Question about Honda Electrical Supplies
honda eu 3000 won't run, cleane bowl,cleaned filter. fresh oil new plug got spark, will run for 10 seconds, the will not crank again. wait 20 min. it like crank an run 10 seconds? Also unpluged ...
Honda generator EG550 wont start. I have a spark and the fuel appears to flow, although when I remove the spark plug there is no smell or sign of petrol. Any ideas what to check next? Cheers Del check
...out where the choke butterfly is. If it has less than 150 hours on it, the rings may also not be seated in, try the above then run it hard on load and check it ...
...seat and the fuel manifold are the prime suspects. I know this generator has the Honda GX270 engine. Some have solenoids (Item 49 this link) ...
...the generator is OFF and filling the crank case with gas. I.e there is debris in the loat needle seat and the fuel is not shutting off when the float is level so it leaks by.. into the engine and ...
...seat if its replaceable if the float is plastic the fuel level may not adjustable your worst case cenario is replacing the carb ? if you cannot get replacement parts but try ...
11 questions posted
Usually answered in minutes!
33 Questions
12 Questions
1 Questions
4 Questions