...making a loud buzzing sound after firing. Iv had it serviced but still making the noise. Any idea? Sounds like air could be leaking from somewhere. Check all connections and listen carefully with it ...
...if i wait 30 secs or so it will fire another 2 or 3 nails then wont fire again Stuart - this sounds like an air problem - you should perform the following test. With the air nailer close to
internal air leak won't pressure up plug in air & it sounds like it's blowing out the vent in handle & won't pressure up & shoot Sounds like the trigger valve is bad. If the air is leaking out of the ...
Question about Dewalt Air Tools & Compressors
compressor runs to pressure shuts off sounds like its bleeding down then tries to restart but just locks up if i manually bleed it to 30- 40 lbs and turn it back on it will restart,this only happens ...
nail gun wont drive nails..just makes a weak popping sound Popping sound indicates stuck driver or worn trigger valve. Remove the head and pull out the driver. The driver should fit snugly in the ...
nailer makes a small clap noise and will not shot nails When the driver or headvalve is stuck in place and the gun is fired, there will be a pop sound or the sound of air being released within the gun
...twon nails at one A nail was jambed now since I removed it the nailer is shooting two at once. sounds like your nail guide has been damaged or worn try your supplier for a new guide hope this ...
Question about NRS Air Tools & Compressors
paslode air nailer fires continually when trigger is pulled Hi, Sounds like you need a trigger repair kit. That`s around $15 Thanks, Jeff
Question about RTO Air Tools & Compressors
...paslode gun has recently started to make loud buzzing springy sound after shooting about 10 nails sounds like the fan (have recently cleaned the gun) took it apart again tested the fan and is ...
Question about RTO Air Tools & Compressors
...the gun thoroughly is it the switch near the top of the gas cartridge or the trigger mechanism sounds like the trigger m8 the only way to cure it is to replace the molded circuit assembly
366 questions posted
Usually answered in minutes!
4 Questions
9 Questions