Life Fitness T3 Treadmill with Advanced Console "error dc 1" Questions

...DC voltage at connector P6 pins 1 and 2. Verify that LED 4 on the Motor Controller flashes as the motor moves. Let me know if you need any more help. Fitness Fix-It i have treadmill t50 its says fet ...

error out. I can't get any information on the output voltage of the board so I can test it. They just want to sell the new $500 + dollar board. Lets eliminate the motor first, unplug unit remove motor

...error 1 Its a york Barbell treadmill and is model number T-406 LA Ok! how I say, just send your motor DC to repair, at the same time, check the engine controller. any diode or mosfet is bad or ...

...error led (red) turn on, P1 displayed on the screen. What is the problem. Thanks MOTOR ELECTRICO BH FITNESS 2.0 H.P.P.180V DC-4A.desimantado, perdida de potenciaprecio.605276703 ...

...dC-1 code. switched the power off and back on, code gone. Do I need to follow up on the code? Reset the error follow the steps. God bless you 1 Unplug the treadmill. Locate the console key and place ...

...ERROR" Is red SERIAL lamp on the motor control board lit? Is the yellow RLC lamp on the motor control board lit? 1. Unplug the treadmill from its 2. Wl alk on the belt manually. (push belt) 3. Does ...

...error code, but the motor will not turn. If you have a multimeter, you can test to make sure you have DC output from the controller spades if not replace the control board. If you have DC output, but ...

...error message. If it operates on an open-loop system, the computer will run normally but the motor will not turn. 6) If you have a multimeter, you can test to make sure you have DC output from the ...

...error message. If it operates on an open-loop system, the computer will run normally but the motor will not turn. 6) If you have a multimeter, you can test to make sure you have DC output from the ...

...error occurs (errors 20-26). 1. Set the treadmill circuit breaker in the â??onâ? position. Using a DC voltmeter, measure the voltage between terminal 3 of J2 (green wire) and terminal 4 of ...