...working fine, however all of a sudden it became unblanced, i stop it to see what the problem was and then it dropped from about 3 inch, and now there is no power, would appreciate your advice thank ...
...working, any ideas How long have you let it run for after turning it back on ? Some treadmills have a re calibration test built in and will incline to the max and work its way down. During this time ...
...incline adjustment was not working. So, I did the following. 1. Turn off, unplug the treadmill and wait for an hour (this is for safety 2. Remove the black motor cover 3. Observe the transformer to ...
...incline adjustment was not working. So, I did the following. 1. Turn off, unplug the treadmill and wait for an hour (this is for safety 2. Remove the black motor cover 3. Observe the transformer to ...
Question about Precor Exercise & Fitness
My 954i treadmill will not increase the belt speed when the button is pressed . It will start at 1.0 and decrease when the down arrow is pressed until it stops. What do I need to try and Fix? only the
belt feels like it slips when I'm walking I've tightened the belt to where I can raise the belt center about 2-3 inches. The belt is centered fine on the rollers. The belt is worn in the ...
working near the rear roller. Remove any loose clothing and tie back your hair. Be very careful to keep your finger or any other object clear of the belt and rollers, especially in front of the roller
Question about Precor Exercise & Fitness
...incline and speed) stopped working at the same time. I own and operate a 24 hour gym and it a favorite. What can I do to fix this issue asap? Thank you for your time There is a small control board ...
...working, the numbers change on the display, and the incline works, it may be the lower circuit board or the generator. If it is a very old unit, it may be the electromagnet or the data cable that ...
46 questions posted
Usually answered in minutes!
191 Questions
96 Questions
34 Questions
36 Questions
21 Questions