Precor 9.21 Treadmill "9" Questions

error code E-9 appears what does this mean press start runs for half a second then stops and E-9 appears May not be much help, but try cleaning all the sensors you can find. May be some lint if an ...

audiostrider 600 software not working It only works at 9 or 10 resistance. It will not go any lower. I put new batteries in but it still will only run at 9 or 10 on the disk and also without the disk ...

cybex 530t error 9 Error 9 is most commonly triggered by worn motor brushes. I would suggest checking and possibly replacing the motor brushes. When you are changing them, it is strongly suggested to ...

... the link below will help you find the deck and belt needed for your model. Precor Repair Parts for 9 45 9 45i Treadmills Consumer SPORTSMITH ...

... the link below will help you find the deck and belt needed for your model. Precor Repair Parts for 9 45 9 45i Treadmills Consumer SPORTSMITH ...

...DOES NOT POWER UP. I CHANGED THE POWER BOARD WITH NO RESULTS. POWER BOARD 120 VOLT LIGHT IS ON. 9 VOLT DC LIGHT IS ON. PWM & TACH LIGHTS ARE NOT LIT. CONSOL DOES NOT LIGHT UP If its a Icon ...

...lights up and looks good but when you press start, motor does not work at all and E1 appears after 9 seconds. I checked the wiring and there doesn't seem to be any power going to the motor during

My 933i is tripping my house circuit breaker at higher speeds. I think there is more resistance in the belt (It's never been serviced). When a running belt has excessive wear, it creates a lot of ...

Have a Precor M9.1 treadmill which cuts off after about 5 to minutes of use. It can be reset immediately and will run for another 5 to 10 minutes before cutting off again. The belt is well aligned and

My Cybex 520T is comming up with Error 9 on the Screen We have lost our manual and are struggling to figure out what the problem is!! Can anyone be my hero? As the treadmill wont function while the ...